FixVault
Home › Nissan-Datsun › 2004 › Sentra SE-R › Repair and Diagnosis › External Pages › Different car › Section 164 (Electronic Suspension) › System Tests › Test B: Input Signal Check (Test Mode Check) › Without Scan Tool

Without Scan Tool

WARNING: This page is about a different car, the 2003 Lexus LS 430, 2002 Lexus LS 430, and 2001 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch off. Set each test item to condition 1 as shown in illustration. See Figure.
  2. Using special tool (09843-18040), jumper between terminals Ts and CG of (DLC3). See Figure.
  3. Start engine. At this time the absorber control indicator light illuminates for 2 seconds. Then it flashes at .25 second intervals. If the absorber control indicator does not flash, check Ts terminal circuit. See TEST E: Ts TERMINAL CIRCUIT .
  4. Change each test item to condition 2. See Figure. Check that absorber control indicator light illuminates for one second.
  5. Using special tool (09843-18040), jumper between terminals Tc and CG of (DLC3). See Figure. Keep the connection between Ts and CG.
  6. Read DTC output by the flashing pattern on absorber control indicator light. See RETRIEVING DIAGNOSTIC TROUBLE CODES  under SELF-DIAGNOSTIC SYSTEM. If DTC is not signaled, check the Tc terminal circuit. See TEST C: Tc TERMINAL CIRCUIT .
  7. Turn ignition switch off. Disconnect special tools.
About FixVault