Front Power Window Motor LH Circuit Check

WARNING: This page is about a different car, the 2006 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH OUTPUT SIGNAL

Turn ignition switch ON.
Check voltage between main power window and door lock/unlock switch connector D7 terminals 12, 16 and ground.

TERMINAL VOLTAGE SPECIFICATION

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
D7	12	Ground	UP	0
	12		DOWN	Battery voltage
	16		UP	Battery voltage
	16		DOWN	0

Fig 1: Checking Voltage Between Connector D7 Terminals 12, 16 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 2.

NG: Replace main power window and door lock/unlock switch. Refer to "FRONT DOOR "

CHECK POWER WINDOW MOTOR CIRCUIT

Turn ignition switch OFF.
Disconnect main power window and door lock/unlock switch and front power window motor LH.

Check continuity between main power window and door lock/unlock switch connector and front power window motor LH connector.

TERMINAL CONTINUITY

Connector	Terminal	Connector	Terminal	Continuity
A	Terminal	B	Terminal	Continuity
Main power window and door lock/unlock switch: D7	12	Front power window motor LH: D9	1	Yes
Main power window and door lock/unlock switch: D7	16	Front power window motor LH: D9	5	Yes

Check continuity between main power window and door lock/unlock switch connector and ground.

TERMINAL CONTINUITY

Connector	Terminal	Ground	Continuity
A
Main power window and door lock/unlock switch: D7	12		No
	16		No

Fig 2: Checking Continuity Between Main Power Window And Door Lock/Unlock Switch Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace front power window motor LH. Refer to , "FRONT DOOR GLASS REGULATOR "

NG: Repair or replace harness.