Rear Power Window Motor RH Circuit Check

WARNING: This page is about a different car, the 2006 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK REAR POWER WINDOW SWITCH RH OUTPUT SIGNAL

Turn ignition switch OFF.
Disconnect rear power window motor RH.
Turn ignition switch ON.
Check voltage between rear power window motor RH connector and ground.

TERMINAL VOLTAGE SPECIFICATION

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
Rear power window motor RH: D304	1	Ground	UP	0
	1		DOWN	Battery voltage
	2		UP	Battery voltage
	2		DOWN	0

Fig 1: Checking Voltage Between Rear Power Window Motor RH Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace rear power window motor RH. Refer to , "REAR DOOR GLASS REGULATOR "

NG: GO TO 2.

CHECK REAR POWER WINDOW MOTOR RH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect rear power window switch RH.
3. Check continuity between rear power window switch RH connector (A) and rear power window motor RH connector (B).
  6 - 1: Continuity should exist.
  
  7 - 2: Continuity should exist.
Fig 2: Checking Continuity Between Rear Power Window Switch RH Connector (A) And Rear Power Window Motor RH Connector (B)
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 3.

NG: Repair or replace harness.
CHECK POWER SUPPLY
1. Connect rear power window switch RH.
2. Turn ignition switch ON.
3. Check voltage between rear power window switch RH connector D303 terminal 8 and ground.
  8 - Ground: Battery voltage
Fig 3: Checking Voltage Between Rear Power Window Switch RH Connector D303 Terminal 8 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace rear power window switch RH. Refer to "REAR DOOR "

NG: Repair or replace harness.