Front Door Lock Actuator RH Check

1. Turn ignition switch OFF.
2. Disconnect BCM and front door lock actuator RH.
3. Check continuity between BCM connector M19 terminals 50, 51 and front door lock actuator RH connector D114 terminals 2, 3.
   TERMINALS CONTINUITY REFERENCE
   
   

   Terminals		Continuity
   50	3	Yes
   51	2	Yes

4. Check continuity between BCM connector M19 terminals 50, 51 and body ground.
   TERMINALS CONTINUITY REFERENCE
   
   

   Terminals		Continuity
   50	Ground	No
   51		No

   Fig 1: Identifying Continuity Between BCM Connector Terminals 50, 51 And Front Door Lock Actuator RH Connector Terminals 2, 3

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: GO TO 2.

NG: Repair or replace harness.

1. Reconnect BCM.
2. Check voltage between BCM connector M19 terminals 50, 51 and ground.
   TERMINALS VOLTAGE REFERENCE
   
   

   Connector	Terminals		Condition	Voltage (V) (Approx.)
   	(+)	(-)
   M19	50	Ground	Door lock/unlock switch is turned to LOCK	0 --> Battery voltage for 300 ms
   	51		Door lock/unlock switch is turned to UNLOCK	0 --> Battery voltage for 300 ms

   Fig 2: Identifying Voltage Between BCM Connector M19 Terminals 50, 51 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Replace front door lock actuator RH. Refer to "REMOVAL AND INSTALLATION ".

NG: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".