FixVault
Home › Nissan-Datsun › 2004 › Sentra SE-R › Repair and Diagnosis › External Pages › Different car › Section 1814 (Seats) › Automatic Drive Positioner › Mirror Motor LH Circuit Check

Mirror Motor LH Circuit Check

WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DOOR MIRROR LH MECHANISM 

    Check the following items.

    Operation malfunction caused by a foreign object caught in door mirror face edge.

    OK or NG 

    OK: GO TO 2.

    NG: Repair the malfunctioning parts, and check the symptom again.

  2. CHECK FUNCTION 

    With CONSULT-II 

    Check the operation with "MIRROR MOTOR LH" in the ACTIVE TEST.

    TEST ITEM DESCRIPTION

    Test item Description
    MIRROR MOTOR LH The mirror motor LH moves the mirror UP/DOWN and LEFT/RIGHT by receiving the drive signal.

    Without CONSULT-II 

    GO TO 3.

    OK or NG 

    OK: Mirror motor LH circuit is OK.

    NG: GO TO 3.

    Fig 1: CONSULT-II Screen Display - MIRROR MOTOR LH In ACTIVE TEST
    G04199939Courtesy of NISSAN MOTOR CO., U.S.A.
  3. CHECK MIRROR MOTOR LH CIRCUIT HARNESS CONTINUITY 
    1. Turn ignition switch OFF.
    2. Disconnect automatic drive positioner control unit and door mirror LH.
    3. Check continuity between automatic drive positioner control unit connector M41 terminals 16, 31, 32 and door mirror LH connector D13 terminals 9, 10, 11.

      16 - 11: Continuity should exist. 

      31 - 10: Continuity should exist. 

      32 - 9: Continuity should exist. 

      Fig 2: Identifying Continuity Between Automatic Drive Positioner Control Unit Connector M41 Terminals 16, 31, 32 And Door Mirror LH Connector D13 Terminals 9, 10, 11
      G04199940Courtesy of NISSAN MOTOR CO., U.S.A.
    4. Check continuity between automatic drive positioner control unit connector M41 terminals 16, 31, 32 and ground.

      16 - Ground: Continuity should not exist. 

      31 - Ground: Continuity should not exist. 

      32 - Ground: Continuity should not exist. 

    OK or NG 

    OK: GO TO 4.

    NG: Repair or replace harness.

  4. CHECK MIRROR MOTOR SIGNAL 
    1. Connect the automatic drive positioner control unit and door mirror LH.
    2. Turn ignition switch to ACC.
    3. Check voltage between door mirror LH connector and ground.
      TERMINALS VOLTAGE REFERENCE

      Connector Terminals Condition Voltage (V) (Approx.)
      (+) (-)
      D13 10 Ground Mirror motor is operated UP 1.5 - Battery voltage
      Other than above 0
      9 Mirror motor is operated LEFT 1.5 - Battery voltage
      Other than above 0
      11 Mirror motor is operated DOWN or RIGHT 1.5 - Battery voltage
      Other than above 0
      Fig 3: Identifying Voltage Between Door Mirror LH Connector And Ground
      G04199941Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: Replace door mirror LH. Refer to "DOOR MIRROR ASSEMBLY ".

    NG: Repair or replace harness.

About FixVault