Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Remove center console lower cover. Refer to "INSTRUMENT PANEL ".
Remove yaw rate/side/decel G sensor nuts.
CAUTION:
- Do not use power tools to remove or install yaw rate/side/decel G sensor.
- Do not drop or strike the yaw rate/side/decel G sensor.
Disconnect harness connector and remove the yaw rate/side/decel G sensor.

Fig 1: Yaw Rate/Side/Decel G Sensor Nuts With Torque Specification
Courtesy of NISSAN MOTOR CO., U.S.A.