Removal and Installation: Installation

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Refer to "POWER STEERING GEAR AND LINKAGE " and "POWER STEERING OIL PUMP " for tightening torques.
NOTE: Do not reuse non-reusable parts.
Ensure that hose is properly installed on tube to specification.
CAUTION: Do not apply power steering fluid to surface between tube and hose.
To install the eye joint on the power steering pump, align the projection of the eye joint into the notch of the power steering pump. Make sure the eye joint is properly installed on the power steering pump, then tighten the eye bolt to specification.
Connect the harness connector into the power steering pressure switch securely.