FixVault
Home › Nissan-Datsun › 2004 › Sentra SE-R › Repair and Diagnosis › External Pages › Different car › Section 2043 (Body, Lock & Security System) › Automatic Back Door System › Back Door Warning Chime System Inspection

Back Door Warning Chime System Inspection

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. BACK DOOR WARNING CHIME CIRCUIT INSPECTION 
    1. Turn ignition switch OFF.
    2. Disconnect back door warning chime and back door control unit.
    3. Check continuity between back door warning chime connector (B) D514 terminal 2 and back door control unit connector (A) B55 terminal 6.

      2 - 6 : Continuity should exist. 

    4. Check continuity between back door warning chime connector (B) D514 terminal 2 and ground.

      2 - Ground : Continuity should not exist. 

    OK or NG 

    OK: GO TO 2.

    NG: Repair or replace harness.

    Fig 1: Checking Continuity Between Back Door Warning Chime Connector (B) Terminal 2 And Back Door Control Unit Connector (A) Terminal 6, And Between Connector (B) Terminal 2 And Ground
    G04907234Courtesy of NISSAN MOTOR CO., U.S.A.
  2. BACK DOOR WARNING CHIME CIRCUIT INSPECTION 
    1. Check continuity between back door warning chime connector (B) D514 terminal 1 and back door control unit connector (A) B55 terminal 9.

      1 - 9 : Continuity should exist. 

    2. Check continuity between back door warning chime connector (B) D514 terminal 1 and ground.

      1 - Ground : Continuity should not exist. 

      Fig 2: Checking Continuity Between Back Door Warning Chime Connector (B) Terminal 1 And Back Door Control Unit Connector (A) Terminal 9, And Between Connector (B) Terminal 1 And Ground
      G04907235Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: Replace warning chime.

    NG: Repair or replace harness.

About FixVault