Door Mirror Remote Control Switch Ground Circuit Inspection

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect door mirror remote control switch.
3. Check continuity between door mirror remote control switch connector D10 terminal 7 and ground.
  7 - Ground : Continuity should exist.
OK or NG

OK: GO TO 2.

NG: Repair or replace harness.

Fig 1: Checking Continuity Between Door Mirror Remote Control Switch Connector M7 Terminal 7 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK DOOR MIRROR REMOTE CONTROL SWITCH (CHANGEOVER SWITCH)

Check continuity between door mirror remote control switch terminals as follows.

TERMINALS CONTINUITY CHART

Terminals		Condition	Continuity
5	7	Changeover switch RIGHT position	Yes
5		Other than above	No
6		Changeover switch LEFT position	Yes
6		Other than above	No

Fig 2: Checking Continuity Between Door Mirror Remote Control Switch Terminal 7 And Terminals 5 & 6

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Check the condition of the harness and the connector.

NG: Replace door mirror remote control switch.