Element Check

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Attach probe circuit tester (ohm setting) to antenna terminal on each side.

Fig 1: Attaching Circuit Tester To Antenna Terminal
- When measuring continuity, wrap tin foil around the top of probe. Then, press the foil against the wire with your finger.
  
  Fig 2: Wrapping Tin Foil Around Top Of Probe
If an element is broken, no continuity will exist.

Fig 3: Attaching Probe Circuit Tester To Antenna Broken Terminal
To locate a break, move probe along element. Tester indication will change abruptly when probe passes the broken point.

Fig 4: Checking Continuity