Inspection After Installation
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Before starting engine, check oil/fluid levels including engine coolant and engine oil. If less than required quantity, fill to the specified level. Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".
- Use procedure below to check for fuel leakage.
- Turn ignition switch ON (with engine stopped). With fuel pressure applied to fuel piping, check for fuel leakage at connection points.
- Start engine. With engine speed increased, check again for fuel leakage at connection points.
- Run engine to check for unusual noise and vibration.
- Warm up engine thoroughly to make sure there is no leakage of Fuel, exhaust gas, or any oils/fluids including engine oil and engine coolant.
- Bleed air from passages in lines and hoses, such as in cooling system.
- After cooling down engine, again check oil/fluid levels including engine oil and engine coolant. Refill to specified level, if necessary.
- Summary of the inspection items:
SUMMARY OF INSPECTION ITEMS
| Item | Before starting engine | Engine running | After engine stopped | ||
|---|---|---|---|---|---|
| Engine coolant | Level | Leakage | Level | ||
| Engine oil | Level | Leakage | Level | ||
| Other oils and fluids(1) | Level | Leakage | Level | ||
| Fuel | Leakage | Leakage | Leakage | ||
| Exhaust gas | - | Leakage | - | ||
|
|||||