FixVault
Home › Nissan-Datsun › 2004 › Sentra SE-R › Repair and Diagnosis › External Pages › Different car › Section 2100 (Power Steering System) › Power Steering Oil Pump › Disassembly and Assembly › Assembly

Disassembly and Assembly: Assembly

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Mount oil pump in soft jawed vise as required.
  1. Check if drive shaft assembly turns smoothly.
  2. Install bracket to power steering oil pump, and tighten the two bracket bolts to specification.
  3. Install pulley to drive shaft assembly, then tighten lock nut to specification.
  4. Install washers and joint to power steering oil pump, then tighten union bolt to specification.
    NOTE: Do not reuse washers.
  5. Apply a coat of NISSAN PSF or equivalent to O-ring and install O-ring to suction pipe. Refer to "RECOMMENDED FLUIDS AND LUBRICANTS ".
  6. Install suction pipe to power steering oil pump and tighten bolts to the specification.
About FixVault