Disassembly and Assembly: Seatback

WARNING: This page is about a different car, the 2011 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.

Disassembly

CAUTION:

Only complete seatback assemblies can be replaced.
When removing or installing the seat trim, handle it carefully to keep dirt out and avoid damage.

Remove the seatback assembly. Refer to "REMOVAL AND INSTALLATION ".
Remove the headrest.
From inside of the seatback, squeeze the headrest holder tabs at the base of the stay pipe and pull upward to remove.
NOTE: Before installing the headrest holder, check its orientation (front/rear and right/left).

Fig 1: Identifying Headrest Holder
Remove the snap ring and the lumbar support lever knob (if equipped).

Fig 2: Identifying Lumbar Support Lever Knob And Snap Ring

Assembly

Assembly is in the reverse order of disassembly.