Bleeding Brake System
WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Refill with new brake fluid. Refer to "FOR USA AND CANADA: FLUIDS AND LUBRICANTS " (United States and Canada), "FOR MEXICO: FLUIDS AND LUBRICANTS " (Mexico).
- Do not reuse drained brake fluid.
- Do not let brake fluid splash on the painted surfaces of the body. This might damage the paint, so when splashing it, immediately wipe off the area and wash away with water.
- Before servicing, disconnect ABS actuator and electric unit (control unit) connector or battery negative terminal.
- While bleeding, monitor the master cylinder brake fluid level.
- Turn ignition switch OFF and disconnect ABS actuator and electric unit (control unit) connector or battery negative terminal.
- Connect a vinyl tube to the rear right bleed valve.
- Fully depress brake pedal 4 to 5 times.
- With brake pedal depressed, loosen bleed valve to let the air out, and then tighten it immediately.
- Repeat steps 3 and 4 until no more air comes out.
- Tighten bleed valve to the specified torque. Refer to "EXPLODED VIEW OF BRAKE CALIPER " (front disc brake), "EXPLODED VIEW OF BRAKE CALIPER " (rear disc brake).
- Perform steps 2 to 6 at each wheel, with master cylinder reservoir tank filled at least half way, bleed air from the front left, rear left, and front right bleed valve, in that order.