Accelerator Pedal Position Sensor
WARNING: This page is about a different car, the 2006 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- Reconnect all harness connectors disconnected.
- Turn ignition switch ON.
- Check voltage between ECM terminals 106 (APP sensor 1 signal), 98 (APP sensor 2 signal) and ground under the following conditions.
Courtesy of NISSAN MOTOR CO., U.S.A.
TERMINAL VOLTAGE CHARTTerminal Accelerator pedal Voltage 106 (Accelerator pedal position sensor 1) Fully released 0.5 - 1.0V Fully depressed 4.2 - 4.8V 98 (Accelerator pedal position sensor 2) Fully released 0.25 - 0.5V Fully depressed 2.0 - 2.5V - If NG, replace accelerator pedal assembly and go to next step.
- Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
- Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
- Perform "IDLE AIR VOLUME LEARNING ".