DTC Confirmation Procedure
WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
WITH CONSULT-II
- Turn ignition switch ON.
- Select "DATA MONITOR" mode with CONSULT-II.
- Start engine and wait maximum of 2 consecutive minutes.
- If 1st trip DTC is detected, go to Diagnostic Procedure .
WITH GST
Follow the procedure "WITH CONSULT-II" above.