FixVault
Home › Nissan-Datsun › 2004 › Sentra SE-R › Repair and Diagnosis › External Pages › Different car › Section 393 (Air Bag Restraint Systems) › Disposal Procedures › Off-Vehicle Deployment › Driver-side AIR Bag Module

Driver-side AIR Bag Module

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM  . Remove driver-side air bag module from vehicle and place module on a clean, dry work bench, with trim cover facing upward. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION.
  2. Firmly secure Air Bag Module Bracket (J41246) in a vise. Using wire at least 0.04" (1 mm) in diameter, secure driver-side air bag module to air bag module bracket in two places.
  3. Position a fully charged 12-volt battery at least 16 feet (4.9 m) from deployment area. See Fig 1 . Connect Deployment Tool (J38381) to air bag module connector using Deployment Adapter (J38381-80). Connect Red clip of deployment tool to positive battery terminal and Black clip to negative battery terminal. Ensure that deployment tool power light glows Green. If deployment tool power light glows Red, reverse battery connections and recheck light.
  4. Ensure no one is within 16 feet (4.9 m) of air bag module. Press deployment tool button to deploy driver air bag module.
Fig 1: Preparing To Deploy Air Bag Module
G96F05302Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault