FixVault
Home › Nissan-Datsun › 2004 › Sentra SE-R › Repair and Diagnosis › External Pages › Different car › Section 423 (Engine Control System - DTC) › DTC P0011, P0021: IVT Control › DTC Confirmation Procedure › With CONSULT-II

With CONSULT-II

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
  2. Start engine and warm it up to the normal operating temperature.
  3. Maintain the following conditions for at least 6 consecutive seconds.

    Hold the accelerator pedal as steady as possible.

    Fig 1: Test Parameters
    G00875849Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 2: CONSULT-II Display Screen
    G00875850Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Let engine idle for 10 seconds.
  5. If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

    If the 1st trip DTC is not detected, go to next step.

  6. Maintain the following conditions for at least 20 consecutive seconds.
    Fig 3: Maintain The Following Conditions For At Least 20 Consecutive Seconds
    G00875851Courtesy of NISSAN MOTOR CO., U.S.A.
  7. If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
About FixVault