Ignition System: Distributor: Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Nissan Xterra, 2002 Nissan Sentra, 2002 Nissan Quest, 2002 Nissan Pathfinder, and 2002 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse removal procedure. Ensure mark(s) or indentations on distributor shaft and housing are aligned. Check distributor rubber "O" ring seal and replace as necessary.
After installing distributor, ensure distributor rotor is aligned with mark made during removal or set at cylinder No. 1 spark plug position. Check and adjust timing. See THROTTLE POSITION SWITCH, IGNITION TIMING & IDLE SPEED in ON-VEHICLE ADJUSTMENTS article. Tighten distributor hold-down bolt to specification. See TORQUE SPECIFICATIONS .