With Consult-II

WARNING: This page is about a different car, the 2005 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

Start engine (VDC switch OFF).
Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT-II. The vehicle speed on CONSULT-II should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.
If NG, go to "Diagnostic Procedure ".

If OK, go to following step.
Select "DATA MONITOR" mode with CONSULT-II.
Warm engine up to normal operating temperature.

Maintain the following conditions for at least 60 consecutive seconds.

CONDITION MAINTAIN

ENG SPEED	1,700 - 6,000 RPM
COOLAN TEMP/S	More than 70°C (158°F)
B/FUEL SCHDL	5.5 - 31.8 (A/T) msec
B/FUEL SCHDL	5.0 - 31.8 (M/T) msec
Shift lever	Except P or N position (A/T) Except Neutral position (M/T)
PW/ST SIGNAL	OFF

Fig 1: Selecting "DATA MONITOR" Mode With CONSULT-II

Courtesy of NISSAN MOTOR CO., U.S.A.

If 1st trip DTC is detected, go to "Diagnostic Procedure ".