Procedure For Malfunction B And C

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 11V at idle. 

With CONSULT-II 

1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch OFF and wait at least 5 seconds.
3. Turn ignition switch ON again and select "DATA MONITOR" mode with CONSULT-II.
   Fig 1: Identifying Display

   Courtesy of NISSAN MOTOR CO., U.S.A.
4. Start engine and run it for at least 1 minute at idle speed.
5. If 1 ST trip DTC is detected, go to Diagnostic Procedure 

With GST 

Follow the procedure "With CONSULT-II".