FixVault
Home › Nissan-Datsun › 2005 › 350Z 2D Convertible, Standard › Repair and Diagnosis › Engine Performance › Engine Control System › ASCD Brake Switch › Component Inspection › ASCD Brake Switch

ASCD Brake Switch

  1. Turn ignition switch OFF.
  2. Disconnect ASCD brake switch harness connector.
  3. Check continuity between ASCD brake switch terminals 1 and 2 under the following conditions.
    CONTINUITY SPECIFICATION

    CONDITION Continuity
    Brake pedal:Fully released Should exist.
    Brake pedal:Slightly depressed Should not exist.

    If NG, adjust ASCD brake switch installation, refer to "BRAKE PEDAL ", and perform step 3 again.

    Fig 1: ASCD Brake Switch Terminals 1 & 2 Continuity Test
    G02402234Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault