FixVault
Home › Nissan-Datsun › 2005 › 350Z 2D Convertible, Standard › Repair and Diagnosis › Engine Performance › Engine Control System › ASCD Brake Switch › Component Inspection › Stop Lamp Switch

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    Fig 1: M/T & A/T Models Stop Lamp Switch Connector Terminals 1 & 2 Continuity Test
    G02402236Courtesy of NISSAN MOTOR CO., U.S.A.
    CONTINUITY SPECIFICATION

    Condition Continuity
    Brake pedal: Fully released Should not exist
    Brake pedal: Slightly depressed Should exist.

    If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step 3 again.

About FixVault