FixVault
Home › Nissan-Datsun › 2005 › Pathfinder LE, 4WD › Repair and Diagnosis › Engine Performance › Engine Control System › DTC P1706: PNP Switch › Diagnostic Procedure

Diagnostic Procedure

  1. CHECK DTC WITH TCM 

    Refer to TROUBLE DIAGNOSIS .

    OK or NG 

    • OK: GO TO 2.
    • NG: Repair or replace.
  2. CHECK STARTING SYSTEM 

    Turn ignition switch OFF, then turn it to START.

    Does starter motor operate? 

    Yes or No 

  3. CHECK PNP SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT-I 
    1. Turn ignition switch OFF.
    2. Disconnect A/T assembly harness connector.
    3. Disconnect combination meter harness connector.
    4. Check harness continuity between A/T assembly terminal 9 and combination meter terminal 17.

      Refer to WIRING DIAGRAM .

      • Continuity should exist. 
    5. Also check harness for short to ground and short to power.

    OK or NG 

    • OK: GO TO  5.
    • NG: GO TO 4.
  4. DETECT MALFUNCTIONING PART 

    Check the following.

    • Harness connectors M31, E152
    • Harness connectors E5, F14
    • Harness for open or short between A/T assembly and combination meter.
      • Repair open circuit or short to ground or short to power in harness or connectors.
  5. CHECK PNP SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT-II 
    1. Disconnect ECM harness connector.
    2. Check harness continuity between ECM terminal 102 and combination meter terminal 7.

      Refer to WIRING DIAGRAM .

      • Continuity should exist. 
    3. Also check harness for short to ground and short to power.

    OK or NG 

    • OK: GO TO  7.
    • NG: GO TO 6.
  6. DETECT MALFUNCTIONING PART 

    Check the following.

    • Harness connectors E152, M31
    • Harness for open or short between ECM and combination meter
      • Repair open circuit or short to ground or short to power in harness or connectors.
  7. CHECK PNP SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT-III 
    1. Check harness continuity between A/T assembly terminal 9 and TCM terminal 8. Refer to DTC P0615 START SIGNAL CIRCUIT .
      • Continuity should exist. 
    2. Also check harness for short to ground and short to power.

    OK or NG 

    • OK: GO TO 8.
    • NG: Repair open circuit or short to ground or short to power in harness or connectors.
  8. CHECK INTERMITTENT INCIDENT 

    Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .

    OK or NG 

    • OK: GO TO 9.
    • NG: Repair or replace.
  9. REPLACE COMBINATION METER 

    Refer to COMBINATION METERS .

    • : INSPECTION END 
About FixVault