Diagnostic Trouble Codes Confirmation Procedure
CAUTION:
Always drive at a safe speed.
NOTE:
- If DTC P0011 or P0021 is displayed with DTC P1111 or P1136, first perform trouble diagnosis for DTC P1111 or P1136. Refer to DTC P1111, P1136 IVT CONTROL SOLENOID VALVE .
- If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is between 10V and 16V at idle.
WITH CONSULT-II
- Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
- Start engine and warm it up to the normal operating temperature.
- Maintain the following conditions in DTC P0011, P0021 CONFIRMATION PROCEDURE - CONDITIONS (1 OF 2) for at least 6 consecutive seconds. Hold the accelerator pedal as steady as possible.DTC P0011, P0021 CONFIRMATION PROCEDURE - CONDITIONS (1 OF 2)
ENG SPEED 1, 200 - 2, 000 rpm COOLAN TEMP/S 60 - 120°C (140 - 248°F) B/FUEL SCHDL More than 3.5 msec Selector lever P or N position - Stop vehicle with engine running and let engine idle for 10 seconds.
- If the 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .
If the 1st trip DTC is not detected, go to next step.
- Maintain the following conditions in DTC P0011, P0021 CONFIRMATION PROCEDURE - CONDITIONS (2 OF 2) for at least 20 consecutive seconds.DTC P0011, P0021 CONFIRMATION PROCEDURE - CONDITIONS (2 OF 2)
ENG SPEED 1, 700 - 3, 175 rpm (A constant rotation is maintained.) COOLAN TEMP/S 70 - 105°C (158 - 221°F) Selector lever 1st or 2nd position Driving location uphill Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.) - If the 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .
WITH GST
Follow the procedure "WITH CONSULT-II" above.