Diagnostic Trouble Codes Confirmation Procedure
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10V at idle.
With CONSULT-II
- Turn ignition switch ON.
- Select "DATA MONITOR" mode with CONSULT-II.
- Start engine and let it idle for 1 second.
- If DTC is detected, go to "DIAGNOSTIC PROCEDURE "
With GST
Follow the procedure "WITH CONSULT-II" above.