FixVault
Home › Nissan-Datsun › 2005 › Sentra SE-R › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Engine Control System (QG18DE)) › DTC P1122: Electric Throttle Control Function › Component Inspection › Throttle Control Motor

Throttle Control Motor

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect electric throttle control actuator harness connector.
  2. Check resistance between terminals 3 and 6.
    • Resistance: Approximately 1 - 15 Ω [at 25 °C (77°F)] 
    3. Fig 1: Checking Resistance Between Throttle Control Motor Connector Terminals 3 And 6
    G02450151Courtesy of NISSAN MOTOR CO., U.S.A.
  3. If NG, replace electric throttle control actuator and go to next step.
  4. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
  5. Perform "IDLE AIR VOLUME LEARNING ".
About FixVault