FixVault
Home › Nissan-Datsun › 2005 › Sentra SE-R › Repair and Diagnosis › Restraints › Air Bag, SRS › Supplemental Restraint System › Front Side Air Bag Module › Removal

Front Side Air Bag Module: Removal

WARNING: Removal of front side air bag module should only be done to allow deployment of front side air bag module prior to disposal of seatback assembly. 

Only complete seatback assemblies can be replaced. Refer to REMOVAL AND INSTALLATION .

CAUTION:
  • Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes. 
  • Always work from the rear of air bag module. 
  1. Open seat back zipper to access module.
  2. Pull up the seat back trim.
  3. Remove the Torx nuts coated with bonding agent from front side air bag module.
  4. Remove harness clips. Front side air bag module can then be removed.
    Fig 1: Front Side Air Bag Module
    G02451858Courtesy of NISSAN MOTOR CO., U.S.A.
CAUTION:
  • Always place front side air bag module with the stud bolt side facing down. 
  • Do not attempt to disassemble air bag module. 
  • Do not insert any foreign objects (screwdriver, etc.) into air bag module connector. 
    Fig 2: Identifying Placing Direction Of Front Side Air Bag Module
    G02451859Courtesy of NISSAN MOTOR CO., U.S.A.
  • Replace front seatback assembly if it has been dropped or sustained an impact. 
  • Do not expose front seatback assembly to temperatures exceeding 90°C (194°F). 
  • Do not allow oil, grease or water to come in contact with the air bag module. 
  • After air bag inflates, the front seatback assembly must be replaced. 
    Fig 3: Precaution While Handling Sensitive Part
    G02451860Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault