FixVault
Home › Nissan-Datsun › 2005 › Xterra SE, RWD › Repair and Diagnosis › Engine Performance › System › Engine Control System - System And Component Testing › Ignition Signal › Component Inspection › Condenser-1

Component Inspection: Condenser-1

  1. Turn ignition switch OFF.
  2. Disconnect condenser harness connector.
  3. Check resistance between condenser terminals 1 and 2.
    ON BOARD DIAGNOSTIC LOGIC

    Resistance Above 1 Ω at 25°C (77°F)
    Fig 1: Checking Resistance Between Condenser Terminals 1 And 2
    G03607405Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault