FixVault
Home › Nissan-Datsun › 2006 › 350Z 2D Convertible, Automatic › Repair and Diagnosis › Engine Performance › System › Engine Control System - Introduction › Basic Service Procedure › Exhaust Valve Timing Control Learning (M/T Models) › Operation Procedure › With CONSULT-II

With CONSULT-II

  1. Start engine and warm it up to normal operation temperature.
  2. Set shift lever in neutral position and confirm that following electrical or mechanical loads are not applied.
    • Headlamp switch is OFF
    • Air conditioner switch is OFF
    • Rear defogger switch is OFF
    • Steering wheel is in the straight-ahead position, etc
  3. Keep the engine speed between 1, 800 and 2, 000 RPM.
  4. Select "EXH V/T CONTROL LEARN" in "WORK SUPPORT" mode with CONSULT-II.
    Fig 1: CONSULT-II DISPLAY - EXH V/T CONTROL LEARN
    G04080366Courtesy of NISSAN NORTH AMERICA, INC.
  5. Touch "START" and wait 20 seconds.
  6. Make sure that "CMPLT" is displayed on CONSULT-II screen.

    Learning completed : CMPLT 

    Learning not yet : YET 

    Fig 2: CONSULT-II DISPLAY - CMPLT
    G04080367Courtesy of NISSAN NORTH AMERICA, INC.
About FixVault