FixVault
Home › Nissan-Datsun › 2006 › Altima SE-R, Standard › Repair and Diagnosis › External Pages › Different car › Section 179 (Brake Control System) › Brake Control System - Abs › Actuator And Electric Unit (Assembly) › Installation

Actuator And Electric Unit (Assembly): Installation

WARNING: This page is about a different car, the 2005 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: After installation of ABS actuator and electric unit (control unit), refill brake fluid. Then bleed air from system. Refer to "BLEEDING BRAKE SYSTEM ".
  1. Position ABS actuator and electric unit (control unit) in vehicle.
  2. Install and tighten ABS actuator and electric unit (control unit) nuts and bolts.
  3. Install brake pipes to ABS actuator and electric unit (control unit), then tighten flare nuts. Refer to "HYDRAULIC CIRCUIT ".
  4. Connect ABS actuator and electric unit (control unit) harness connectors.
  5. Install windshield wiper motor and linkage assembly. Refer to "INSTALLATION ".
  6. Reconnect battery cable.
About FixVault