FixVault
Home › Nissan-Datsun › 2006 › Maxima SL › Repair and Diagnosis › Engine Performance › System › Engine Control System - DTCS P0447 To P1168 › DTC P0500 VSS › DTC Confirmation Procedure › With Consult-II

With Consult-II

  1. Start engine (TCS switch or VDC switch OFF).
  2. Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT-II. The vehicle speed on CONSULT-II should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.

    If NG, go to "DIAGNOSTIC PROCEDURE ".

    If OK, go to following step.

  3. Select "DATA MONITOR" mode with CONSULT-II.
    4. Fig 1: CONSULT-II Display - DATA MONITOR
    G04160658Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Warm engine up to normal operating temperature.
  5. Maintain the following conditions for at least 60 consecutive seconds.
    CONDITION SPECIFICATION

    ENG SPEED 1, 600 - 6, 000 rpm
    COOLAN TEMP/S More than 70°C (158°F)
    B/FUEL SCHDL 5.3 - 31.8 msec (M/T models)
    4.4 - 31.8 msec (A/T models)
    Shift lever Except P or N position (A/T models)
    Except Neutral position (M/T models)
    PW/ST SIGNAL OFF
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "
About FixVault