FixVault
Home › Nissan-Datsun › 2006 › Quest Base › Repair and Diagnosis › Engine Performance › System › Engine Control System - DTCS P1212 To P2A03 › DTC P2127, P2128 App Sensor › Component Inspection › Accelerator Pedal Position Sensor

Accelerator Pedal Position Sensor

  1. Reconnect all harness connectors disconnected.
  2. Turn ignition switch ON.
  3. Check voltage between ECM terminals 106 (APP sensor 1 signal), 98 (APP sensor 2 signal) and ground under the following conditions.
    ACCELERATOR PEDAL POSITION SENSOR VOLTAGE

    Terminal Accelerator pedal Voltage
    106 (Accelerator pedal position sensor 1) Fully released 0.5 - 1.0V
    Fully depressed 4.2 - 4.8V
    98 (Accelerator pedal position sensor 2) Fully released 0.25 - 0.5V
    Fully depressed 0.2 - 2.5V
  4. If NG, replace accelerator pedal assembly and go to next step.
  5. Perform , "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
  6. Perform , "THROTTLE VALVE CLOSED POSITION LEARNING ".
  7. Perform , "IDLE AIR VOLUME LEARNING ".
    Fig 1: Checking Voltage Between Ground And ECM Connector Terminals 98 & 106
    G04075209Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault