Checking Equipment

WARNING: This page is about a different car, the 2006 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

When ordering the following equipment, contact your NISSAN distributor .

TOOL DESCRIPTION CHART

Tool name	Description
NISSAN CONSULT-II (J-44200) CONSULT-II unit (Tester internal soft: Resident version 3.3.0) and accessories Program cards AED04C and AEN02C (for NATS) or later. To confirm the best combination of these softwares, refer to CONSULT-II Operation Manual. CONSULT-II CONVERTER. "CONSULT-II Pigtail" cable.

CAUTION:

Previous CONSULT-II "I" and "Y" DLC-I and DLC-II cables should NOT be used anymore because their DDL connector pins can be damaged during cable swapping.
If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.
If CONSULT-II CONVERTER is not connected with CONSULT-II, vehicle occur the "FAIL SAFE MODE" which is "LIGHT UP the HEAD LIGHT" and/or "COOLING FAN ROTATING" when CONSULT-II is started.

NOTE:

The CONSULT-II must be used in conjunction with a program card.
CONSULT-II does not require loading (Initialization) procedure.
Be sure the CONSULT-II is turned off before installing or removing a program card.