FixVault
Home › Nissan-Datsun › 2007 › X-Trail SE, Standard › Repair and Diagnosis › Engine Performance › Testing & Diagnosis › Engine Control System - Component Testing › Ignition Signal › Component Inspection › ECM Relay

ECM Relay

  1. Apply 12V direct current between ECM relay terminals 1 and 2.
  2. Check continuity between relay terminals 3 and 5, 6 and 7.
    CONTINUITY CHART

    Condition Continuity
    12V direct current supply between terminals 1 and 2 Yes
    OFF No
    Fig 1: Identifying ECM Relay
    G06152957Courtesy of NISSAN MOTOR CO., U.S.A.
  3. If NG, replace ECM relay.
About FixVault