FixVault
Home › Nissan-Datsun › 2007 › Xterra Off Road, Standard › Repair and Diagnosis › Engine Performance › Testing & Diagnosis › Engine Control System - Component And System Testing › ASCD Brake Switch › Component Inspection › Stop Lamp Switch

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check harness continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    Fig 1: Checking Harness Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04895074Courtesy of NISSAN NORTH AMERICA, INC.
    CONTINUITY REFERENCE CHART

    Condition Continuity
    When brake pedal: Fully released. Should not exist.
    When brake pedal: Slightly depressed. Should exist.

    If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step  3 again.

About FixVault