FixVault
Home › Nissan-Datsun › 2008 › 350Z 2D Convertible, Standard › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - DTCS P0448 To P1212 › DTC P1078 P1084 EVT Control Position Sensor › Component Inspection › Exhaust Valve Timing Control Position Sensor

Exhaust Valve Timing Control Position Sensor

  1. Disconnect exhaust valve timing control position sensor harness connector.
  2. Loosen the fixing bolt of the sensor.
  3. Remove the sensor.
  4. Visually check the sensor for chipping.
    Fig 1: Identifying Exhaust Valve Timing Control Position Sensor
    G04875198Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Check resistance as shown below.
    RESISTANCE SPECIFICATION

    Terminal No. (Polarity) Resistance Ω [at 25°C (77°F)]
    1 (+) - 2 (-) Except 0 or ∞
    1 (+) - 3 (-)
    2 (+) - 3 (-)
  6. If NG, replace exhaust valve timing control position sensor.
    Fig 2: Checking Resistance Between Exhaust Valve Timing Control Position Sensor Terminals
    G04875327Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault