DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

   TESTING CONDITION: 

   Before performing the following procedure, confirm that battery voltage is between 10V and 16V at idle. 

   GO TO 2.

With CONSULT-III 

1. Activate "INSPECTION MODE 1 " to start engine, and warm up engine to normal operating temperature.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON (READY) and select "DATA MONITOR" mode with CONSULT-III.
4. Maintain the following conditions for at least 10 consecutive seconds. Hold the accelerator pedal as steady as possible.
   ENGINE SPEED AND COOLANT TEMPERATURE SPECIFICATION
   
   

   VHCL SPEED SE	70 km/h (43 mph) or more
   ENG SPEED	800 - 2,000 rpm
   COOLANT TEMP/S	80°C (176°F) or more
   Shift lever	D position

   CAUTION: Always drive at a safe speed.
5. Stop vehicle.
6. Check 1st trip DTC.

With GST 

Follow the procedure "With CONSULT-III" above.

Is 1st trip DTC detected? 

YES : Go to "DIAGNOSIS PROCEDURE "

NO : GO TO 3.

With CONSULT-III 

1. Maintain the following conditions for at least 10 consecutive seconds.
   ENGINE SPEED AND COOLANT TEMPERATURE SPECIFICATION
   
   

   ENG SPEED	1,700 - 3,175 rpm (A constant rotation is maintained.)
   COOLANT TEMP/S	More than 70°C (221°F)
   Shift lever	D position
   Driving location uphill	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

   CAUTION: Always drive at a safe speed.
2. Check 1st trip DTC.

With GST 

Follow the procedure "With CONSULT-III" above.

Is 1st trip DTC detected? 

YES : Go to "DIAGNOSIS PROCEDURE "

NO : INSPECTION END