DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

   GO TO 2.

With CONSULT-III 

1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode with CONSULT-III.
3. Check that "COOLANT TEMP/S" is above 10°C (50°F).

With GST 

Follow the procedure "With CONSULT-III" above.

Is it above 10°C (50°F)? 

YES : INSPECTION END

NO : GO TO 3.

With CONSULT-III 

1. Activate "INSPECTION MODE 1 " to start engine, and run engine for 65 minutes at idle speed.
2. Check 1st tip DTC.

   If "COOLANT TEMP/S" increases to more than 10°C (50°F) within 65 minutes, turn ignition switch OFF because the test result will be OK. 

   CAUTION: Be careful not to overheat engine.

With GST 

Follow the procedure "With CONSULT-III" above.

Is 1st trip DTC detected? 

YES : "DIAGNOSIS PROCEDURE "

NO : INSPECTION END