DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

Do you have CONSULT-III? 

YES : GO TO 2.

NO : GO TO  3.

With CONSULT-III 

1. Activate "INSPECTION MODE 1 " to start engine, and warm up engine to normal operating temperature.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Turn ignition switch OFF and wait at least 10 seconds.
5. Turn ignition switch ON (READY).
6. Select "POOR ENG PWR P1196" of "ENGINE PERFORMANCE" in "DTC WORK SUPPORT" mode with CONSULT-III.
7. Touch "START".
8. Drive vehicle at a speed of 60 km/h (37 MPH) or more until "TESTING" on CONSULT-III changes to "COMPLETED". (It will take approximately 10 seconds.)
   CAUTION: Always drive vehicle at a safe speed.
   NOTE: Keep the vehicle speed as steady as possible during the cruising.
9. Touch "SELF-DIAG RESULT".

Which is displayed on CONSULT-III? 

OK : INSPECTION END

NG : Go to "DIAGNOSIS PROCEDURE ".

With GST 

1. Activate "INSPECTION MODE 1 " to start engine, and warm up engine to normal operating temperature.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Turn ignition switch OFF and wait at least 10 seconds.
5. Turn ignition switch ON (READY).
6. Drive vehicle at a speed of 60 km/h (37 MPH) or more for at least 10 seconds.
   CAUTION: Always drive vehicle at a safe speed.
   NOTE: Keep the vehicle speed as steady as possible during the cruising.
7. Check DTC.

Is DTC detected? 

YES : Go to "DIAGNOSIS PROCEDURE ".

NO : INSPECTION END