Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform "THROTTLE VALVE CLOSED POSITION LEARNING : Special Repair Requirement ".
4. Turn ignition switch ON.
5. Set shift lever to D position.
6. Check the voltage between ECM harness connector and ground.
   VOLTAGE SPECIFICATION
   
   

   ECM		Ground	Condition		Voltage
   Connector	Terminal
   F13	37 (TP sensor 1 signal)	Ground	Accelerator pedal	Fully released	More than 0.36V
   				Fully depressed	Less than 4.75V
   	38 (TP sensor 2 signal)			Fully released	Less than 4.75V
   				Fully depressed	More than 0.36V

Is the inspection result normal? 

YES : INSPECTION END

NO : GO TO 2.

1. Replace electric throttle control actuator.
2. Go to "SPECIAL REPAIR REQUIREMENT ".

INSPECTION END