FixVault
Home › Nissan-Datsun › 2008 › Maxima SL › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - DTCS P0448 To P0850 › DTC P0451 EVAP Control System Pressure Sensor › DTC Confirmation Procedure

DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

WITH CONSULT-III 

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
  5. Start engine and wait at least 40 seconds.
    NOTE: Do not depress accelerator pedal even slightly.

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ."

WITH GST 

Follow the procedure "WITH CONSULT-III" above.

About FixVault