Without Abs Or CVT

1. Remove vehicle speed sensor.
2. Turn ignition switch ON.
3. Rotate vehicle speed sensor while checking voltage between combination meter harness connector M24 terminals 6 and 7.
   CONNECTOR TERMINAL VOLTAGE SPECIFICATION
   
   

   Terminals				Voltage (Approx.)
   (+)		(-)
   Connector	Terminal	Connector	Terminal
   M24	7	M24	6	0.5

   Fig 1: Checking Voltage Between Combination Meter Harness Connector M24 Terminals 6 And 7

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Replace combination meter. Refer to "COMBINATION METER ".

NG: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect vehicle speed sensor connector.
3. Check resistance between vehicle speed sensor terminals 1 and 2.
   CONNECTOR TERMINAL RESISTANCE SPECIFICATION
   
   

   Terminals				Resistance value (Approx.)
   (+)		(-)
   Component	Terminal	Component	Terminal
   Vehicle speed sensor	1	Vehicle speed sensor	2	250Ω

   Fig 2: Checking Resistance Between Vehicle Speed Sensor Terminals 1 And 2

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Check harness or connector between combination meter and vehicle speed sensor.

NG: Replace vehicle speed sensor.