FixVault
Home › Nissan-Datsun › 2008 › Sentra SE-R › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - Component Testing (Qr25DE) › ASCD Brake Switch › Component Inspection › Stop Lamp Switch

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04925545Courtesy of NISSAN MOTOR CO., U.S.A.
    TERMINALS CONTINUITY CHART

    Condition Continuity
    Brake pedal: Fully released. Should not exist.
    Brake pedal: Slightly depressed. Should exist.

    If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step  3 again.

About FixVault