FixVault
Home › Nissan-Datsun › 2008 › Sentra SE-R › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - DTCS P0137 To P0445 (Qr25DE) › DTC P0181 FTT Sensor › DTC Confirmation Procedure › With Consult-III

With Consult-III

  1. Turn ignition switch ON wait at least 10 seconds.
  2. Check 1st trip DTC.

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

    If 1st trip DTC is not detected, go to following step.

  3. Select "DATA MONITOR" mode with CONSULT-III.
  4. Check "COOLAN TEMP/S" value.

    If the "COOLAN TEMP/S" is less than 60°C (140°F), the result will be OK.

    If the "COOLAN TEMP/S" is above 60°C (140°F), go to the following step.

  5. Cool engine down until "COOLAN TEMP/S" signal is less than 60°C (140°F).
  6. Wait at least 10 seconds.
  7. Check 1st trip DTC.
  8. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
About FixVault