FixVault
Home › Nissan-Datsun › 2008 › Sentra SE-R › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - DTCS P1148 To P2A03 (Qr25DE) › DTC P2135 TP Sensor › DTC Confirmation Procedure

DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 8V at idle. 

  1. Start engine and let it idle for 1 second.
  2. Check DTC.
  3. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
About FixVault