FixVault
Home › Nissan-Datsun › 2008 › Sentra SE-R › Repair and Diagnosis › External Pages › Different car › Section 192 (Engine Control System - DTCS U1000 To P0159) › DTC P0127 IAT Sensor › DTC Confirmation Procedure › With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wait until engine coolant temperature is less than 90°C (194°F)
    1. Turn ignition switch ON.
    2. Select "DATA MONITOR" mode with CONSULT-II.
      3. Fig 1: Identifying CONSULT-II Display - DATA MONITOR
      G04900237Courtesy of NISSAN NORTH AMERICA, INC.
    3. Check the engine coolant temperature.
    4. If the engine coolant temperature is not less than 90°C (194°F), turn ignition switch OFF and cool down engine.
      • Perform the following steps before engine coolant temperature is above 90°C (194°F).
  2. Turn ignition switch ON.
  3. Select "DATA MONITOR" mode with CONSULT-II.
  4. Start engine.
  5. Hold vehicle speed at more than 70 km/h (43 MPH) for 100 consecutive seconds.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
About FixVault