Diagnostic Procedure
WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK COMBINATION METER FUNCTION
Refer to "COMBINATION METERS ".
OK or NG
OK: GO TO 2.
NG: Go to "FUEL LEVEL SENSOR UNIT INSPECTION ".
- CHECK FUEL TANK TEMPERATURE SENSOR POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect "fuel level sensor unit and fuel pump" harness connector.
- Turn ignition switch ON.
- Check voltage between "fuel level sensor unit and fuel pump" terminal 4 and ground with CONSULT-II or tester.
Voltage: Approximately 5V
OK or NG
OK: GO TO 4.
NG: GO TO 3.
- DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors E41, C1
- Harness for open or short between ECM and "fuel level sensor unit and fuel pump"
Repair harness or connector.
- CHECK FUEL TANK TEMPERATURE SENSOR GROUND CIRCUIT FOR OPEN AND SHORT
- Turn ignition switch OFF.
- Disconnect combination meter harness connector.
- Check harness continuity between "fuel level sensor unit and fuel pump" terminal 2 and combination meter terminal 9. Refer to Wiring Diagram .
Continuity should exist.
- Also check harness for short to ground and short to power.
OK or NG
OK: GO TO 6.
NG: GO TO 5.
- DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors E41, C1
- Harness connectors E152, M31
- Harness for open or short between "fuel level sensor unit and fuel pump" and combination meter
Repair open circuit or short to ground or short to power in harness or connector.
- CHECK FUEL TANK TEMPERATURE SENSOR
Refer to "COMPONENT INSPECTION ".
OK or NG
OK: GO TO 7.
NG: Replace fuel level sensor unit.
- CHECK INTERMITTENT INCIDENT
Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".
INSPECTION END