FixVault
Home › Nissan-Datsun › 2008 › Versa SL, 4D Hatchback, Standard › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - DTCS U1000 To P0133 › DTC P0011 IVT Control › DTC Confirmation Procedure › With Consult-II

With Consult-II

  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
  2. Start engine and warm it up to the normal operating temperature.
  3. Maintain the following conditions for at least 6 consecutive seconds.

    Hold the accelerator pedal as steady as possible.

    ENGINE SPEED AND COOLANT TEMPERATURE SPECIFICATIONS

    ENG SPEED 2, 000 RPM (A constant rotation is maintained.)
    COOLAN TEMP/S More than 60°C (140°F)
    B/FUEL SCHDL More than 3.87 msec
    Shift lever P or N position (A/T, CVT)
    Neutral position (M/T)
    Fig 1: CONSULT II Display - DATA MONITOR
    G04812040Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Let engine idle for 10 seconds.
  5. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

    If 1st trip DTC is not detected, go to next step.

  6. Maintain the following conditions for at least 20 consecutive seconds.
    ENGINE SPEED AND COOLANT TEMPERATURE SPECIFICATIONS

    ENG SPEED 1, 200 - 3, 175 RPM (A constant rotation is maintained.)
    COOLAN TEMP/S 70 - 105°C (158 - 221°F)
    Shift lever 1st or 2nd position
    Driving location uphill Driving vehicle uphill
    (Increased engine load will help maintain the driving conditions required for this test.)
  7. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
About FixVault