Reference Value From Consult-III
CAUTION:
The display shows the control unit calculation data, so a normal value might be displayed even in the event the output circuit (harness) is open or short - circuited.
MONITOR ITEM DISPLAY
| Monitor item | Display Content | Data monitor | |
|---|---|---|---|
| Condition | Reference values for normal operation | ||
| WHEEL SENSOR | Wheel speed calculated using signals from all four wheel sensors | Vehicle stopped | 0 km/h (0 MPH) |
| While driving (Note 1) | Nearly matches the speedometer display (± 10% or less) | ||
| IN ABS S/V OUT ABS S/V | Operation status of all solenoids | When the actuator solenoid operates or during a fail-safe | ON |
| When the actuator relay operates and the actuator solenoid does not operate | OFF | ||
| EBD WARN LAMP | Brake warning lamp on condition (Note 2) | Brake warning lamp ON | ON |
| Brake warning lamp OFF | OFF | ||
| STOP LAMP SW | Brake pedal operation | Brake pedal depressed | ON |
| Brake pedal not depressed | OFF | ||
| MOTOR RELAY | Motor and motor relay operation status | When the motor relay and motor are operating | ON |
| When the motor relay and motor are not operating | OFF | ||
| ACTUATOR RLY | Actuator relay operation status | When the actuator relay is operating | OFF |
| When the actuator relay is not operating | ON | ||
| ABS WARN LAMP | ABS warning lamp on condition (Note 3) | ABS warning lamp ON | ON |
| ABS warning lamp OFF | OFF | ||
| BATTERY VOLT | Battery voltage supplied to ABS control unit | Ignition switch ON | 10 - 16V |
| GEAR | Determined gear shift position from the A/T PNP switch signal | Driving | M/T vehicles are always left in 1. |
| ENGINE RPM | Engine running | With engine stopped | 0 RPM |
| With engine running | Almost in accordance with tachometer display | ||
| FAIL SIGNAL | Fail signal status | During ABS fail-safe During EBD fail-safe |
ON |
| Note 1: Confirm tire pressure is normal. Note 2: Serves as EBD warning lamp. Note 3: ON/OFF timing of ABS warning lamp ON: For approximately 1 second after the ignition switch is turned on or when an error is detected. OFF: Approximately 1 second after the ignition switch is turned on (when system is normal). |
|||